Hemming rollformer HR-1

Hemming rollformer HR-1 designed by our company to make very common operation- flat sheet metal bending to 180 degrees. Without our HR-1 machine this trim bending operation can be performed on sheet metal folding machine, but in this case first step is to bend 130 angle and after to press the sheet with upper bar to 180 degrees. However, such operation takes a lot of time, especially if you need to make both sides hemming and quality of product is much better on sides than in center cause of design features of bending machine. But with our hemming rollformer HR-1 it will come much more faster and interesting- the machine can form both sides hem at the same time and provide the top quality of product for full length. You can also adjust hemming level depends on your preferences. Roll forming trim machine HM-1 has width easy adjustable system so it takes minimum time to adjust rollfromer from one sheet width to another with special adjusting handle. 

You can also roll one side hem with machine, it can be necessary when you need to produce many products with different widths. To make one-side operations there is special support system on machine.

Thus, hemming rollformer HR-1 can help our customers to make trim production operations much faster and get better quality final products.

Therefore, our machine will help you to increase trim production possibility and earn much more money that investments you spend on equipment.